dynatec IN-6000 사용 지침 및 유지 관리 매뉴얼 - 페이지 7

{카테고리_이름} dynatec IN-6000에 대한 사용 지침 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dynatec IN-6000 8 페이지. Instantaneous safety gear

INSTRUCTIONS: IN-6000

Cod: DYN 27.04

Date: 20/10/2020

Revision: 04

Figure 6: Safety gear synchronisation using the T-1 driving bar

4 INSPECTIONS AND MAINTENANCE

4.4 STORAGE AND SERVICE LIFE

The safety gear should be stored in a cool, dry place. It should be protected from excessive lighting. It should

never be exposed to severe weather conditions.

Storage temperature: 5 - 40ºC

Storage humidity: 15 - 85% without condensation.

The safety gears' packaging should be clean and dry, so that they can be clearly identified.

It is not permitted to place constant or unbalanced loads on a package, which may cause the package to be

bent, or to allow products to be stacked one on top of the other. When stacking products or packages, the

storage height should take into account their load and stability.

If the criteria established for proper maintenance are observed, the safety gears may have the same service

life as the rest of the installation's fixed elements provided that their proper functioning is ensured and

controlled. The element's service life is not affected by grease, dust or dirt due to the shaft's condition or to

environmental conditions differing from those stated in this manual.

Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the

customer area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/