Dynatech STAR 사용 지침 및 유지 관리 매뉴얼 - 페이지 16

{카테고리_이름} Dynatech STAR에 대한 사용 지침 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynatech STAR 18 페이지. Overspeed governor

INSTRUCTIONS: Star Cod: DYN 09.1.19

Date: 14/12/2022 Revision: 19

maintenance staff, although they should be more frequent in the case of an especially corrosive environment.

Dynatech will not be responsible for any problem or accident caused by not observing the prescriptions and

recommendations described, both in these instructions and in the EEC Type-examination certificate documents

9.1 STORAGE AND SERVICE LIFE

The overspeed governor must be stored in a cool, dry place. It must be protected from excessive light and never be

exposed to the open air.

Storage temperature: 5 - 40ºC.

Storage Humidity: 15 - 85% without condensation

Overspeed governor packages should be clean and dry so that they can be clearly identified.

Constantly leaning an unbalanced load on packages, which may cause bending, or the accumulation of products

stacked on top of each other is not allowed. When placing products or product packages on top of each other, the

storage height should correspond to the packages' load and stability.

If the established criteria of this manual are observed, the overspeed governor's service life is set by the wear of his

main pulley groove, which depends on the installation duty cycle. When estimating the element's service life, the

effects of grease, dust or dirt due to the shaft's condition or to environmental conditions differing from those stated in

this manual, were not taken into consideration.

The following drawings may be of help when adapting and installing the STAR and STAR PLUS overspeed governor

to the sling.

Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer

area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/