Dynatech IN-3000 사용 지침 및 유지 관리 매뉴얼 - 페이지 6

{카테고리_이름} Dynatech IN-3000에 대한 사용 지침 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynatech IN-3000 9 페이지. Instantaneous safety gear

INSTRUCTIONS: IN-3000

Date: 20/10/2020

Revision: 06

3.2 SAFETY GEAR ADJUSTMENT

⚠

In order to avoid problems with the installation's normal operation, it is very important that the person

carrying out the installation rigorously observes the distances mentioned in this item.

3.2.1

IN-3000 MODEL FOR 8mm and 9mm THICKNESS GUIDE RAILS

The guide rail's position in the block should be adjusted as follows. (see drawing DYN 26.C02.00).

Figure 5: Safety gear adjustment in relation to the guide rail (IN-3000)

3.2.2

IN-3000 MODEL FOR 10mm THICKNESS GUIDE RAILS

The guide rail's position in the block should be adjusted as follows. (see drawing DYN 26/3.C02.00)

Figure 6: Safety gear adjustment in relation to the guide rail (IN-3000 G10)

3.3 COUPLING THE DRIVING BAR

It is the responsibility of the person who installs the safety gear to properly position the driving bar in relation

to the safety gear, as well as to properly synchronise the safety gears controlled by that driving bar. The correct

position is when the safety gear roller is on the bottom of the block.

Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the

customer area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/

Cod: DYN 26.06

Figure 4: Improper assembly