2HEAT TC-300 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} 2HEAT TC-300에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2HEAT TC-300 3 페이지. Programmable plug in thermostat

Programmable Plug in Thermostat TC-300

Parameter Settings

Under off status, press "M" button and "+"button at the same time. You be able to enter the parameter settings. Each

press of "M" button can into next item setting.

No.

Mode Temperature Pre-set.

Pic.A

The Mode temperature can be set as the below following steps:

Press and hold the "M" button for around 3 seconds. The COMFORT mode (pic. A) display.

Change the mode temperature by the "+" or "-" buttons.

Press "M" button , the Energy-saving mode display (pic. B).

Change the mode temperature by the "+" or "-" buttons.

Press "M" button , the holiday mode display (pic. C).

Change the mode temperature by the "+" or "-" buttons.

The comfort function is displayed as a

The energy-saving function is displayed as a

The holiday function is displayed as a

To leave this menu, just wait 10 seconds or just push on the on/off button. The setup will be memorized

by the EEPROM (when this feature is enabled).

Item

Temp. Calibration

High Temp. Limit

Low Temp. Limit

Frost Protection

Dead Band

Heat pump protection

Eeprom( Memory)

Software Version

Pic.B

symbol (e.g. 25.5°C).

symbol (e.g. 20.5°C).

symbol (e.g. 10°C).

Range

-9 ～+9 'C

0 ～ 65 'C

5 ～10 'C

0.5 ～2 'C

0： OFF 1: ON

0:OFF 1: ON

100C

Pic.C