AFINIA LABEL L801 기술 서비스 게시판 - 페이지 4

{카테고리_이름} AFINIA LABEL L801에 대한 기술 서비스 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. AFINIA LABEL L801 4 페이지. By vivid
AFINIA LABEL L801에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지)

After the Goal Post sensors have been identified it is necessary to disperse any debris and particulates that

have built up on the sensors over time. Take your canned air and focus it in the area of each Goal Post

sensor and disperse any debris that appears on both Goal Post sensors.

After the debris has been dispersed take your contact cleaner and spray (heavily) both Goal Post sensors.

Once you have sprayed down the Goal Post sensors utilize your Q-tips to swab any dried up ink on the PCB

board and the black Goal Post sensor.

Hint: Compress the Q-tip between your fingers to allow for the Q-tip to pass between the Goal Post sensor.

At this time the goal post sensors have been cleaned. Connect the service station back to the ribbon cable and

insert the service tray back into the service channel.

For additional support call the Vivid Data Support Team at 1-855-848-4332 Option 2!

Figure 3. Unlocking & Locking Ribbon Cable

Installment 161115