AFINIA LABEL L801 기술 서비스 게시판 - 페이지 2

{카테고리_이름} AFINIA LABEL L801에 대한 기술 서비스 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. AFINIA LABEL L801 4 페이지. By vivid
AFINIA LABEL L801에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지)

Instructions for Removing Service Station & Printhead:

1) Afinia L801:

Remove Printhead:

Using the front display of the Afinia L801 – enter Configuration mode by pushing the

button associated to the Gear.

Enter the Setup menu (option 1) by hitting the return button.

In the Setup menu scroll down to Security (option 4) and hit return.

Next, scroll to Level 2 (option 3) once you enter Level 2 you will be prompted to enter a password. If

you haven't changed your password before then the password should be "123".

Once you have authenticated your password – back out to the Configuration menu and scroll down to

the option Known as Printhead (option 3) and hit the return button.

After entering the Printhead menu scroll down and Eject (option 2) the printhead.

Once the system is done depriming the printhead. Push the latch upright unlocking the printhead –

then lift up and remove the printhead.

Eject Service Station:

Back out to the Configuration menu and scroll down to the option known as Service Station (option 4).

While in the Service Station menu (option 4) scroll down to the Eject (option 2) and hit enter.

As the service station ejects - power off the printer in the front and also on the back of the printer.

Remove the four screws holding the front display panel to the printer. Once this display panel has

been removed you can now access the service station to remove it.

Before removing the service station make sure to disconnect the ribbon cable from the service station.

For additional support call the Vivid Data Support Team at 1-855-848-4332 Option 2!

Installment 161115