Galleon NTS-6002 하드웨어 매뉴얼 - 페이지 8
{카테고리_이름} Galleon NTS-6002에 대한 하드웨어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galleon NTS-6002 18 페이지.
페이지 인쇄INSTALLATION
Position the NTS-6002 on a rack-mount shelf or another convenient location. Note – you will
need to run a cable from this location either to the roof or a window.
Once positioned, connect the AC power cord [see fig 6] at the back of the device and plug
into your electrical outlet.
Then, connect the device to a network using a standard RJ-45 cable [see fig 7]. If your
network supports Dynamic Host Configuration Protocol [DHCP], the NTS-6002 will
automatically obtain an IP Address. For use across an additional network, connect a second
RJ-45 cable to the second port on the device.
You're now ready to connect the antenna [see fig 8 for GPS and fig 9 for Radio]. Connect the
antenna cable to the input port marked 'Antenna' [refer to page 3 - NTS-6002 'At a Glance'
– for guidance]. For optimum GPS antenna performance, mount on a roof. For optimum
Radio antenna performance, mount on a roof and point towards correct transmitter.*
Ensure that you leave enough slack cable to reposition the NTS-6002 device if needed and
remember, the cable distance should not exceed 1,000m.
*Note – avoid positioning antennas in the proximity of air conditioning systems and power
distribution units as they will cause electrical interference.
www.galsys.co.uk
galleonsupport.com
NTS-6002 HARDWARE MANUAL
Figure 6 - AC Power Cord
Figure 7 - RJ-45 Ethernet Cable
8
TEL:
+44 (0) 121 608 4433
FAX:
+44 (0) 121 608 4477