Galleon NTS-6002 Donanım Kılavuzu - Sayfa 8

Sunucu Galleon NTS-6002 için çevrimiçi göz atın veya pdf Donanım Kılavuzu indirin. Galleon NTS-6002 18 sayfaları.

INSTALLATION

 Position the NTS-6002 on a rack-mount shelf or another convenient location. Note – you will

need to run a cable from this location either to the roof or a window.

 Once positioned, connect the AC power cord [see fig 6] at the back of the device and plug

into your electrical outlet.

 Then, connect the device to a network using a standard RJ-45 cable [see fig 7]. If your

network supports Dynamic Host Configuration Protocol [DHCP], the NTS-6002 will

automatically obtain an IP Address. For use across an additional network, connect a second

RJ-45 cable to the second port on the device.

 You're now ready to connect the antenna [see fig 8 for GPS and fig 9 for Radio]. Connect the

antenna cable to the input port marked 'Antenna' [refer to page 3 - NTS-6002 'At a Glance'

– for guidance]. For optimum GPS antenna performance, mount on a roof. For optimum

Radio antenna performance, mount on a roof and point towards correct transmitter.*

Ensure that you leave enough slack cable to reposition the NTS-6002 device if needed and

remember, the cable distance should not exceed 1,000m.

*Note – avoid positioning antennas in the proximity of air conditioning systems and power

distribution units as they will cause electrical interference.

www.galsys.co.uk

galleonsupport.com

NTS-6002 HARDWARE MANUAL

Figure 6 - AC Power Cord

Figure 7 - RJ-45 Ethernet Cable

TEL:

+44 (0) 121 608 4433

FAX:

+44 (0) 121 608 4477