Galleon SignalClocks 설치 및 사용자 설명서 - 페이지 5

{카테고리_이름} Galleon SignalClocks에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galleon SignalClocks 13 페이지. Poe digital clock

SITES WITH NO EXISTING POE EQUIPMENT

Note: Before you configure your unit, make sure you've chosen an area that's appropriate to mount the

clock later, taking into account how long you require the leads to be.

For areas that aren't equipped with a PoE enabled network, then the setup is typically best served

by using a Power Injector.

If you choose this method and have a power injector supplied by Galleon, then connect the

sub/switch to the port labelled "LAN" on the power injector, and then connect the clock to the

port labelled "PoE" on the power injector. Plug the power supply in and wait for the display to

come on, when the unit powers up make a note of the IP address as this will be needed to

configure the unit via telnet later.

Galleon Systems offers a single port PoE injector for sale to support demonstration systems. For

more information on these please call our Sales Team on 0121 608 7230.

After the PoE setup has been completed, the clock can be mounted to the wall.

Step 1 – Locate the two slots on the back of the Signal Clock, which allow the clock to be mounted

to the wall using two screws.

Step 1 - Measure a horizontal line of exactly 300mm in the area of your choice, the end points of

which represent the drilling locations for the screws.

Step 2 – Drill the holes, and insert raw plugs into the wall to prevent the screws from coming

loose.

Step 3 – Fit the screws into the plugs.

Step 5 – When the clock is ready, connect the appropriate cables and hang it on the wall.

www.galsys.co.uk

galleonsupport.com

PoE Digital Clock

Page5

TEL:

+44 (0) 121 608 4433

FAX:

+44 (0) 121 608 4477