AFINIA LABEL L801 교체 - 페이지 4

{카테고리_이름} AFINIA LABEL L801에 대한 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. AFINIA LABEL L801 4 페이지. Replacing microfiber roller

With these components accessible – isolate your Micro-Fiber Roller. Utilizing a small Phillip's head screw

driver. Loosen, but do not remove the screws, holding the plastic locking clips on the left and right side

of the Micro-Fiber Roller in place. After loosening these screws enough, the plastic locking clips should

release.

Figure 4. Loosening screws & unlocking latches holding Micro-Fiber Roller in place

After loosening the screws up and unlocking the plastic latches the Micro-Fiber Roller is accessible.

Remove the used Micro-Fiber Roller install the new Roller after locking the plastic latches back in place

and fasten the screws down.

Final Directions:

At this time the you have completed replacing the Micro-Fiber Roller. Assemble the service station

components back in the correct order. All that is left to do is connect the ribbon cable and return

the service tray back to the print engine.

Installment 1796