DCS DCS-VH-30HS 사용 및 설치 매뉴얼 - 페이지 9

{카테고리_이름} DCS DCS-VH-30HS에 대한 사용 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS DCS-VH-30HS 18 페이지. The professional vent hoods
DCS DCS-VH-30HS에 대해서도 마찬가지입니다: 사용 및 설치 매뉴얼 (18 페이지)

페이지 인쇄

SITE PREPARATION:

In cases where the installation site does not have a soffit structure, the Vent Hood assembly may be

secured directly to the wall from the rear of the unit.

NOTE- When installing the vent hood directly to the rear wall, an adequate structural wall support (studs)

must exist to secure the unit.

NOTE- The DCS Duct Cover should be ordered and installed when installing the vent hood in a site without a

soffit. DCS offers both a 6" and 12" height Duct Covers. Keep the 6 or 12 inch dimension in mind when allow-

ing for clearance between the top of the Vent Hood and the ceiling. (see Fig. 4)

1. With the Vent Hood width, and installation site in mind, mark the centerline of the installation.

2. See the chart in Fig.4 to determine the centerline to centerline dimension of wall mounting holes

for the particular model being installed.

3. Cut away enough drywall (if installed) to expose 2 vertical studs (1 on each side of the Hood

center line) It will be necessary to A) construct a plywood wall insert (See Fig 5) or B) install

aligning wall studs. (See Fig 6).

WALL MOUNTING

After an adequate wall structure has been completed, secure the DCS Duct Cover (6" or 12") to the

top of the vent hood. Carefully lift the hood with the duct cover into the installation site and secure

the hood into the wall structure with 6 (six) mounting screws. Once the Hood assembly has been

secured to the wall, the front of the Soffit Chimney may be removed for ductwork connections.

-GO TO FINISHING THE INSTALLATION Pg.9

FIG.05

No additional

wall studs

needed

Plywood Sheet

(wall hole cut out x drywall thickness")

FIG.06

Additional

Wall Studs

Installed

Centerline of

installation space.