GALLERY 36 사용 설명서 - 페이지 2

{카테고리_이름} GALLERY 36에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GALLERY 36 18 페이지. Canvas stretching machine

Unpacking & Set-up

Inside the cardboard box is:

(1) Canvas stretching machine suspended in custom-made foam pads

(2) Sliding stretcher plates on the stretcher bar (remove black rubber packing mounts)

(1) Foot pedal

(1) Instruction manual

(1) Pair of safety glasses & (2) Hex wrenches.

Your Gallery Stretcher is fully assembled and ready to operate out-of-the-box; the foot

pedal will need to be plugged into the stretching machine and the air compressor. The

foot pedal operates similar to a light switch...only with air. Our foot pedal is configured

to apply air to the machine the moment air is applied; this causes the clamping bar to

"close"... DO NOT have any part of your body near the clamp when applying air.

Depressing the foot pedal cuts off the supply of air, this "opens" the clamp.

1. Remove the stretcher and check for damaged, loose or broken fittings or tubing.

2. Place the foot pedal on the floor, position pedal where it can be easily reached.

3. Plug hose with ¼" NPT fitting into your supply manifold or air compressor.

(See Safety Precautions)

4. Plug the hose, with no fitting, into the canvas stretching machine.

Bench Mounting Your Stretcher

Your machine was designed to be mounted on the side of a typical workbench this is the

most effective method. However, your machine can also be placed on top of any work

surface that can accommodate artwork of the same size.

Mark a "level" line 3.25" down from the top of the workbench (refer to photo below).

Please note that it may be necessary to add a wood plank or sheet of plywood to provide a

flat work surface wide enough to support the angle brackets.

This line represents the top of the shelf, please allow for the thickness of the shelf and

carpet. You can use 12" x 12" metal brackets that can be purchased at any home

improvement store. The end result is to have the top of the stretcher at the same level as

the work surface; this will provide the operator with a relatively seamless work surface.

3.25"