DCS DCS-VH-36 사용 및 설치 매뉴얼 - 페이지 7

{카테고리_이름} DCS DCS-VH-36에 대한 사용 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS DCS-VH-36 18 페이지. The professional vent hoods

SITE PREPARATION:

This DCS Professional Vent Hood has been designed to accommodate

installation into a

I) soffit structure

(ceiling mount), or, for sites without

a soffit structure.

2) directly into the wall through holes provided in the rear panel of the vent hood (wall mount). When

mounting the hood to a soffit, it is recommended

to also utilize the rear panel holes to gain addi-

tional stability and minimize any vibration

noise. We suggest that the final framing and wall finishing

be done with the vent hood at the site to more accurately locate ductwork

and electrical service.

CONSTRUCT

SOFFIT

FRAMING:

I) For a site with a soffit, use 2" x 4"s to construct the soffit framing as shown below in Fig. I. Note

that a minimum opening of 10" is needed to accommodate

the ductwork.

With the centerline of

the installation marked, nail down the 2" x 4"s (wide side down) so that their inner edges are those

specified from the centerline. -see Figs.I & 3 pg.7

Note: The second (outer) set 0f2"x #'s are not necessary on the 30"Models

installation.

2) Make 2 wood shims (2" x 10-1/2" x drywall thickness). Attach them to the framing as shown in

Fig.2. Mount shims flush with inner edges of framing and with front edges II-I/2"

from finished back

wall.

i l

"A" = Center line to inner edge

Finished Drywall

of 2 x 4's. -see rigA.