GALLERY GS-60 사용 설명서

{카테고리_이름} GALLERY GS-60에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GALLERY GS-60 17 페이지.

Support Page

Introduction

The Canvas Stretching Machine is a fully pneumatic canvas stretcher capable of

stretching original art on canvas, giclee prints and any fabric suitable for stretching. The

following is a list of operating parameters that should be observed to ensure a safe and

efficient stretch:

Safety Precautions

Air Pressure: before applying air to your machine, adjust the regulator at your

compressor to produce 90 psi. If you are using a pneumatic staple gun please be sure to

provide what the manufacturer recommends, this may require you to provide a 2 way

manifold from your compressor.

The Clamping Bar has a dedicated pressure regulator and it is set to a point that will not

exceed the Stretcher Bar pressure by more than 10 psi. This is to ensure that the canvas

is permitted to slip just enough to minimize overstretching. The operating pressure of the

Clamping Bar is internally preset to 50

: the clamp and stretcher bar move slowly, they are deceptively powerful.

CAUTION

The force behind them can damage your fingers, please ensure that your hands and

fingers are clear of the clamp at all times. DO NOT place your fingers between the

Clamping Bar and Front Plate at anytime.

Instruction Manual

GS-60

http://www.youtube.com/user/dweaverframe?feature=mhee

Minimum amount of excess canvas 1.5" past the bottom of

stretcher bar and no more than 2.5"

Minimum stretcher bar width .75"

Maximum stretcher bar width 2.5"

Maximum supply air 120 psi

Minimum supply air pressure 90 psi (required for staple gun)

psi....Do Not Adjust This Setting!