HIGHLEAD GC2268-2BXL 사용 설명서 - 페이지 8

{카테고리_이름} HIGHLEAD GC2268-2BXL에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIGHLEAD GC2268-2BXL 11 페이지. Two needle cylindrical bed compound feed lockstitch sewing machine (rotary)

페이지 인쇄

10. Adjusting the stitch length

Turn stitch length dial counter-clockwise to bring the desired value to the top of the

dial so that the value is aligned with the pin.

Reverse feed stitching

1）The machine performs reverse feed stitching as long as the lever is held depressed.

2）The moment you release the lever, the machine resumed the normal stitching mode.

11. Timing between rotating hook motion and needle motion

1）Set feed length (stitch length) to "6" on the feed setting dial.

2） When needle is lifted 2.4mm from the lower dead point, as shown in Figure,

the following positional relationship should be maintained.

· The upper edge of needle eye should be 2.3 mm below the hook point.

· The hook point should be located at the center of needle axis.

· Gap between the hook point and the side face of needle should be 0.0.5mm.

From the library of Superior Sewing Machine & Supply LLC - www.supsew.com

— 6 —