Dynaudio Contour 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Dynaudio Contour에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynaudio Contour 17 페이지.
Dynaudio Contour에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (17 페이지)

페이지 인쇄

Owner's Manual Contour

Fig. 4 Distance to walls.

Distance to back and side

To reduce possible influences from the

walls

back and sidewalls, the distance to

these boundaries should ideally not be

Every loudspeaker not only disperses

less than 0.5 meter (see Fig. 4).

sound energy directly into the room, but

Adapting the bass reflex port

also to the side and even backwards. As

a result, time-delayed reflections occur

and add to the original music signal. Thus,

To minimize low frequency reflections,

when loudspeakers are positioned too

which will be heard as a thickening of the

close to walls, the sound quality can be

sound, the loudspeaker models can be

restricted.

adapted to the room's acoustic character

by using foam plugs in the bass reflex port.

Dynaudio loudspeakers were developed

This will essentially attenuate the room-

to be placed free-standing, and therefore

induced boost in the low frequency range by

they reach their optimum performance

dampening the deep frequencies, yielding

when positioned as clear of any walls as

a more clear and tight sound when the

possible.

loudspeaker is positioned near rear walls.

P18

A, B ≥ 0.5 m

A ≠ B

Fully insert the foam port plugs packed

with your loudspeaker into the bass

reflex port, to attenuate the bass

output (if required).

If the attenuation of the bass volume is

too high (bass level too low) remove the

inner part of the foam plug. Then fully

insert the foam ring in the bass reflex

port. Make sure the ring is formed in

a concentric circular shape within the

port to prevent reduced and turbulent

airflow.

Spikes with sharp peaks

The sharp peaks of the spikes may cause injuries and damage sensitive surfaces like

hardwood flooring or tile.

Be careful when handling the loudspeakers.

Place plates between the spikes and the surface to protect the underlying surface.

Floor-standing

Compact loudspeaker set-up

loudspeaker set-up

The compact models are designed to

The floor-standing models feature a special

offer exceptional performance while taking

base construction, which offers both an

up minimal space. The mini-monitors will

ideal performance and mechanical basis.

realize their optimum performance when

Integrated into the base plinth are four

used in conjunction with a dedicated stand

individual spike assemblies. These stabilize

(such as the Dynaudio Stands) to position

the cabinet on an extremely small contact

them at the proper height while absorbing

area, and therefore prevent any wobbling

any resonance.

while offering optimal resonance control.

The individually adjustable spikes allow

Due to its dimensions, you can also place

leveling of the cabinet on uneven floors.

the loudspeaker on a ledge or shelf or on

top of furniture. But to avoid the possibility

of any negative influence on sound quality,

one should take care to utilize a stable

surface offering a wide enough space in

Positioning

front of the loudspeakers as to not limit the

sound quality and performance. In such

applications or if placing the speakers in

enclosed audio/video furniture, the bass

reflex port can usually be left unplugged

as long as there is minimal clearance to

the boundaries at the top and rear of the

loudspeaker cabinet.

P19