DCS DD24DVT7 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} DCS DD24DVT7에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS DD24DVT7 18 페이지. Dishdrawer series
DCS DD24DVT7에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

SECURE TO THE CABINETRY ON THE SIDES

10a

Open the

drawer halfway.

Using a flat-bladed

screwdriver, prize

the gray

rubber plug out

of the trim moulding.

Using a small Philips

screwdriver,

screw through the trim

moulding, securing the

side mounting bracket

to the cabinetry.

Do not damage the

rubber trimseal.

FIT THE SUPPLIED TOEKICK PANEL

12a

Where the toekick

meets the bottom

of the tub is the

cut-off point

Mark this point

on the toekick

with a pencil

Replace the gray

rubber plug back into

the trim moulding

and ensure the trim

seal is facing forward.

Repeat for all

four brackets.

Lay the toekick face down on

Turn the toekick over and

a chopping board or similiar

score along the same line

Score along with a knife

Gently snap off the excess

OPTIONALLY SECURE TO THE CABINETRY ABOVE

11a

Smooth the edge with a file.

Be careful of sharp edges.

Snap off the two end tabs

(x2)

Slide the toekick onto

the mounting rails

either side and screw

the toekick onto the

bottom of tub on

either side.

Important!

Do not overtighten screw.

The top mounting

brackets will only bend

upwards a maximum

of 3⁄8" (10 mm).

Mounting rail