DCS DD24DVT7 Kurulum Talimatları Kılavuzu - Sayfa 11
Bulaşık Makinesi DCS DD24DVT7 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. DCS DD24DVT7 18 sayfaları. Dishdrawer series
Ayrıca DCS DD24DVT7 için: Hızlı Başlangıç Kılavuzu (2 sayfalar)
Sayfayı Yazdır
SECURE TO THE CABINETRY ON THE SIDES
10a
Open the
drawer halfway.
Using a flat-bladed
screwdriver, prize
the gray
rubber plug out
of the trim moulding.
2
Using a small Philips
screwdriver,
screw through the trim
moulding, securing the
side mounting bracket
to the cabinetry.
Do not damage the
rubber trimseal.
FIT THE SUPPLIED TOEKICK PANEL
12a
Where the toekick
meets the bottom
1
of the tub is the
cut-off point
2
Mark this point
on the toekick
with a pencil
1
Replace the gray
rubber plug back into
the trim moulding
and ensure the trim
seal is facing forward.
Repeat for all
four brackets.
3
5
Lay the toekick face down on
Turn the toekick over and
a chopping board or similiar
score along the same line
4
19
Score along with a knife
Gently snap off the excess
OPTIONALLY SECURE TO THE CABINETRY ABOVE
11a
3
19
Smooth the edge with a file.
Be careful of sharp edges.
6
Snap off the two end tabs
(x2)
7
8
Slide the toekick onto
the mounting rails
either side and screw
the toekick onto the
bottom of tub on
either side.
Important!
Do not overtighten screw.
11
The top mounting
brackets will only bend
upwards a maximum
of 3⁄8" (10 mm).
Mounting rail
9