Dynaudio BM5 mkIII 사용자 설명서 - 페이지 10

{카테고리_이름} Dynaudio BM5 mkIII에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynaudio BM5 mkIII 16 페이지. Active monitor system
Dynaudio BM5 mkIII에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (9 페이지)

페이지 인쇄

Pass by 1 dB.

This switch sets the lower cut-off frequency of the monitor. It is used to match the monitor to a subwoofer. You

can select between 60 Hz or 80 Hz X-over. Flat is used in case you do not use a subwoofer to assist your

monitors. When used with a subwoofer it is recommended to use either 60 Hz or 80 Hz filter, thus allowing a

higher undistorted sound pressure level.

8. Level trim

Use this switch to match the sensitivity of the BM5 mkIII monitor to your source.

High-output Source

If your source has a high output, set switch to the -10 position to reduce sensitivity by 10 dB.

Low-output source

If your source has a low output, set switch to the +4 position to gain 4 dB more sensitivity.

Protection

The BM5 mkIII monitor has several built in protection systems to reduce the risk of hazard or damage due to

overloading.

Both power amplifiers have thermal protection. This activates if a problem should occur, and helps protect both

the electronics and the loudspeaker drivers.

The woofer channel has a built in limiter that protects the woofer unit from too much excursion. It works by

reducing the gain of the circuit when a certain threshold level is reached.

BM User manual