Dynaudio BM5 mkIII User Manual - Page 10

Browse online or download pdf User Manual for Stereo System Dynaudio BM5 mkIII. Dynaudio BM5 mkIII 16 pages. Active monitor system
Also for Dynaudio BM5 mkIII: Owner's Manual (16 pages), Owner's Manual (9 pages)

Print Page

Pass by 1 dB.

This switch sets the lower cut-off frequency of the monitor. It is used to match the monitor to a subwoofer. You

can select between 60 Hz or 80 Hz X-over. Flat is used in case you do not use a subwoofer to assist your

monitors. When used with a subwoofer it is recommended to use either 60 Hz or 80 Hz filter, thus allowing a

higher undistorted sound pressure level.

8. Level trim

Use this switch to match the sensitivity of the BM5 mkIII monitor to your source.

High-output Source

If your source has a high output, set switch to the -10 position to reduce sensitivity by 10 dB.

Low-output source

If your source has a low output, set switch to the +4 position to gain 4 dB more sensitivity.

Protection

The BM5 mkIII monitor has several built in protection systems to reduce the risk of hazard or damage due to

overloading.

Both power amplifiers have thermal protection. This activates if a problem should occur, and helps protect both

the electronics and the loudspeaker drivers.

The woofer channel has a built in limiter that protects the woofer unit from too much excursion. It works by

reducing the gain of the circuit when a certain threshold level is reached.

BM User manual