2iB SC10 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} 2iB SC10에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2iB SC10 5 페이지. Single pump controller
2iB SC10에 대해서도 마찬가지입니다: 설치 및 사용자 설명서 (16 페이지)

Function of the buttons:

The 2iB SC10 is usually used as a Snore Controller. A pump snores (sucks air / stops pumping) when the water level drops too low.

When this happens the current drawn by the pump motor will drop. These buttons allow adjustment of the current at which

snoring and detected and the pump stops. The snoring and thus stop current varies depending upon the pump and its hydraulic

system and so often requires adjustment on-site.

Auto-Set: Press this button when the pump is snoring and the SC10 will automatically adjust the Stop Current based on

Up and Down: These allow the current setpoint to be manually adjusted up and down. Depending on the pump and

Current Display Window

The 2iB SC10 has a display of the motor current. It is very useful for the operators to see the current display when adjusting the

stop current. So including a window in the switchboard door helps.

If you don't want the operators to adjust the setpoint, use a cover or door.

If you want only maintenance staff and not normal operators to adjust the Stop Current, then either:



Mount the Pushbuttons behind a cover or door like this

You could use a transparent plastic cover or a steel/stainless door.



Or, use lockable pushbuttons.

the measured Current.

hydraulics, the setpoint may need adjustment to achieve optimal detection of snoring.