HighPoint SSD7000 Series 설치 매뉴얼 - 페이지 3

{카테고리_이름} HighPoint SSD7000 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint SSD7000 Series 12 페이지. Linux rocky linux
HighPoint SSD7000 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (14 페이지)

페이지 인쇄

Linux Debian on SSD7000 Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux

Debian on the SSD7000 controller.

 Supported system: Debian10.1 /10.2 /10.3 /10.4 /10.5 /10.6 /10.7/ 10.8/10.9/11.3/

11.4/11.5/11.6

 Supported controller: SSD7580A/7580B/7540/7505/7502/7202/7105/7103

2 Installing Linux Debian on SSD7000 controller

If you would like to install Linux Debian onto drives attached to SSD7000 controller,

please perform the following operations:

Step 1 Prepare Your Hardware for Installation

After you attach your NVMe SSD to SSD7000 controller, you can use SSD7000 EFI

Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.

Before installation, you must remove all the NVMe SSD, which are not physically attached

to SSD7000 controller, from your system.

Note

SSD7000 only support EFI boot. If you have other SCSI adapters installed, you must

make sure the SSD7000 controller EFI will be loaded firstly. If not, try to move it to

another PCI slot. Otherwise you may be unable to boot up your system.

Step 2 Check System EFI Settings

In your system EFI SETUP menu, change Boot Sequence in such a way that the system

will first boot from EFI CDROM or EFI a USB flash drive, and then from SSD7000

RAID. Refer to your motherboard EFI manual to see how to set boot sequence.

If your EFI settings do not support such a boot sequence, you can first set it to boot from

EFI CDROM or EFI a USB flash drive. After you finish installation, set SSD7000 RAID

as the first boot device to boot up the system.

1. Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example.

"Advanced->PCIe/PCI/PnP Configuration->CPUSlot PCI-E OPROM"

to "EFI". Suppose SSD7000 is connected to motherboard CPU1 Slot 2 PCI-E X16,

then you should set "CPU1 Slot 2 PCI-E X16 OPROM" to "EFI";

- 1 -