HighPoint SSD7000 Series Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для Компьютерное оборудование HighPoint SSD7000 Series. HighPoint SSD7000 Series 12 страниц. Linux rocky linux
Также для HighPoint SSD7000 Series: Руководство по установке (16 страниц), Руководство по установке (14 страниц)
Печатать страницу
Linux Debian on SSD7000 Installation Guide
1 Overview
The purpose of this document is to provide clear instructions on how to install Linux
Debian on the SSD7000 controller.
Supported system: Debian10.1 /10.2 /10.3 /10.4 /10.5 /10.6 /10.7/ 10.8/10.9/11.3/
11.4/11.5/11.6
Supported controller: SSD7580A/7580B/7540/7505/7502/7202/7105/7103
2 Installing Linux Debian on SSD7000 controller
If you would like to install Linux Debian onto drives attached to SSD7000 controller,
please perform the following operations:
Step 1 Prepare Your Hardware for Installation
After you attach your NVMe SSD to SSD7000 controller, you can use SSD7000 EFI
Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.
Before installation, you must remove all the NVMe SSD, which are not physically attached
to SSD7000 controller, from your system.
Note
SSD7000 only support EFI boot. If you have other SCSI adapters installed, you must
make sure the SSD7000 controller EFI will be loaded firstly. If not, try to move it to
another PCI slot. Otherwise you may be unable to boot up your system.
Step 2 Check System EFI Settings
In your system EFI SETUP menu, change Boot Sequence in such a way that the system
will first boot from EFI CDROM or EFI a USB flash drive, and then from SSD7000
RAID. Refer to your motherboard EFI manual to see how to set boot sequence.
If your EFI settings do not support such a boot sequence, you can first set it to boot from
EFI CDROM or EFI a USB flash drive. After you finish installation, set SSD7000 RAID
as the first boot device to boot up the system.
1. Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example.
"Advanced->PCIe/PCI/PnP Configuration->CPUSlot PCI-E OPROM"
a.
to "EFI". Suppose SSD7000 is connected to motherboard CPU1 Slot 2 PCI-E X16,
then you should set "CPU1 Slot 2 PCI-E X16 OPROM" to "EFI";
- 1 -