Galletti DST 26 기술 및 설치 매뉴얼 - 페이지 3

{카테고리_이름} Galletti DST 26에 대한 기술 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galletti DST 26 8 페이지. Air destratifiers
Galletti DST 26에 대해서도 마찬가지입니다: 기술 및 설치 매뉴얼 (8 페이지)

페이지 인쇄

DST

MAIN FEATURES

In working environments heated with hot air systems the need to keep the

temperature at approximately 18°C, causes the air to stratify at the top of the

room, with much of the heat remaining unused, which is destined to flow

toward the atmosphere.

The DST destratifier eliminates this problem by generating a vertical flow of

air to reduce the difference between the temperature at the floor and the

temperature at the ceiling to about 3°C.

In the hot season the DST destratifier may be used to obtain a good

ventilation.

UNIT DESCRIPTION

(1) Cabinet: side panel

(2) Cabinet: upper/lower panel

(3) Rear panel/fan compartment

(4) Regulation thermostat

(5) Safety grille (fan) supporting motor

(6) Adjustable louvers

(7) electrical box

(8) Overload cut-out

(9) Plastic corner trim on cabinet (left and right)

(10) Conveyor duct

(11) Wall/ceiling mounting brackets

All copying, even partial, of this manual is strictly forbidden

CONSTRUCTIVE FEATURES

Cabinet: made of prepainted sheet metal complete with ABS corner trim,

is complete with adjustable aluminium louvers (spring operated) placed

on the air outlet which allow an optimal distribution of the air.

Axial fan with statically balanced sickle blades housed in a specially

designed compartment that enhances ventilation and reduces noise

emission.

Safety grille made of electrogalvanised steel wire: it supports the motor

and is fixed to the cabinet by means of vibration damping supports.

Motor: standard equipped with:

- two speeds

- power supply 400V - 3 - 50Hz

- delta-star type

- 4 poles operation for model DST 16

- 6 poles operation for all the models from 26 to 66

- tropicalized

- internal thermal protection (klixon)

- IP 55 grade of protection

- Class F windings

Overload cut-out with manual reset for motor protection

Thermostat: connected to the overload cut-out to start and stop the DST

destratifier at the set temperature

Suspending brackets: made of stainless steel metal, for the suspending

the unit from the ceiling.

AP66000443 - 02