Galletti DST 26 기술 및 설치 매뉴얼 - 페이지 5

{카테고리_이름} Galletti DST 26에 대한 기술 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galletti DST 26 8 페이지. Air destratifiers
Galletti DST 26에 대해서도 마찬가지입니다: 기술 및 설치 매뉴얼 (8 페이지)

페이지 인쇄

DST

HOW TO CHOOSE THE DESTRATIFIER

1) Set the units installation height in the environment.

2) Calculate the volume above the units and consider 5 volumes/hour of air

recirculation.

3) Select the unit with air flow rate equal or higher than the overall volume

to recirculate and the proper installation height.

EXAMPLE

dimensions of the building :

- width

40 m

- length 100 m

- height 7.5 m

Destratifier installation height 6 m

The volume above the destratifier is of 3000 sqm; recirculated air flow should

be at least 3000 x 5 = 15000 sqm/h.

The best choice is no. 3 DST 46.

All copying, even partial, of this manual is strictly forbidden

BEFORE STARTING INSTALLATION

Carefully read this manual.

Installation and maintenance may be carried out solely by qualified technicians

specifically trained for this type of equipment, in conformity with current

regulations.

On receiving the equipment, check that it has not undergone any damage

during transport.

INTENDED USE AND OPERATING LIMITS

Galletti S.p.A. will not accept any liability for damage or injury caused as a

result of:

- installation by non-qualified personnel;

- improper use or use in conditions not allowed by the manufacturer;

- failure to perform the maintenance prescribed in this manual;

- use of spare parts other than original factory parts.

The operating limits are:

Air inlet temperature: from -10°C to +40°C

Supply voltage: +/- 10%

usage outside the stated limits is to be considered improper.

AP66000443 - 02