DYNAVOICE MAGIC FX-4 사용자 설명서 - 페이지 3
{카테고리_이름} DYNAVOICE MAGIC FX-4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNAVOICE MAGIC FX-4 12 페이지.
DYNAVOICE MAGIC FX-4에 대해서도 마찬가지입니다: 사용자 설명서 (6 페이지)
페이지 인쇄
Dynavoice Speakers
1. Unpacking and maintenance
We recommend you to unpack your speakers with care. After unpacking your pur-
chased Dynavoice product, we suggest you retain all packaging material for possible
future transports.
1.1 Break-in
The speakers are brand new and have never been used (except for control testing
in the factory). The speakers need to be used for a period of at least 50 hours, as an
initial break-in period. This softens the speaker elements and results in better sound
from your speakers. Attention! Do not play on high volume during the break-in
period.
1.2 Setting up the speakers
Some floor standing models are delivered with some form of spikes or feet. This im-
proves the sound of the speaker and prevents the sound from propagating through
the floor. This is especially beneficial when you are placing the speakers in an apart-
ment and don't want to disturb your neighbours. If the speakers are not delivered
with spikes or feet, you can purchase these separately. Attention! Place the speaker
on a flat, sturdy surface.
2. Connections and setup
2.1 Cables
We recommend the use of heavy gauge loudspeaker cables of high quality. Make
sure to turn off all amplifiers before connecting your new speaker to your Hi-Fi
system.
Connect the cable from the amplifier to the speaker's terminal. Use the marking of
the cables to ensure that the red or "+" mark of the amplifier is connected to the red
or "+" marked port of the speaker terminal. Use the marking of the cables to also
ensure that the black or "-" mark of the amplifier is connected to the black or "-"
marked port of the speaker terminal.
2.2 Bi-Wiring / Bi-Amping (Definition and Challenger series)
Most of Dynavoice's speakers have 4-pole terminals allowing Bi-Wiring. The upper
connection is connected to tweeter/midrange and the lower is connected to the
woofers. It requires two cables for each speaker to use Bi-Wire. First of all, make
sure that the amplifier is turned off. Remove the gold-plated connection between
the upper and lower connectors of the terminal. Connect one cable from the upper
1