HighPoint RocketRAID mini-SAS 6G HBA Series 설치 매뉴얼 - 페이지 6

{카테고리_이름} HighPoint RocketRAID mini-SAS 6G HBA Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint RocketRAID mini-SAS 6G HBA Series 13 페이지. Bootable raid
HighPoint RocketRAID mini-SAS 6G HBA Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)

페이지 인쇄

Note: A 32 or 64‐bit EFI rom image is needed on the RocketRAID eSATA 6G series

controller to support booting to Mac OS X. Refer to the above table load the correct

EFI rom image to support your Mac Pro system.

Tip: The 32 or 64‐bit EFI rom image is found in the CD of the RocketRAID eSATA 6G

series controller and it is also available for download on the

http://www.hptmac.com website.

Before, installing the RocketRAID eSATA 6G series controller make sure the

computer is turned off and unplugged from its power source. Take appropriate

electrostatic discharge precautions:

Your computer is a static‐sensitive device. It is susceptible to invisible damage if not

protected during installation.

We recommend proper grounding by using a grounding strap. Make sure to work in

a clean and static‐free area, and avoid wearing clothing that retains static charges.

Part 3 Hardware Installation and Verification

Before installing the RocketRAID eSATA 6G series controller

• Make sure computer is turned off and unplugged from its power source

• Take appropriate electrostatic discharge precautions:.

Remove the PCIe slot cover.

Gently insert the RocketRAID eSATA 6G series controller into the PCIe slot and

secure the bracket to the computer chassis according to your chassis specifications.

After installing the RocketRAID eSATA 6G series controller, restart your computer.

After your computer has started, insert the Driver & Software Installation Disc to

install the necessary drivers for your computer's operating system.

Hardware Verification

Verifying the RocketRAID eSATA 6G series controller is installed into the Mac Pro

system:

Step 1: Click on About this Mac