adeptus 6+2 Drawer Wide Roll Cart 76169 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} adeptus 6+2 Drawer Wide Roll Cart 76169에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. adeptus 6+2 Drawer Wide Roll Cart 76169 8 페이지. Matte black/white finish

페이지 인쇄

adeptus 6+2 Drawer Wide Roll Cart 76169 조립 지침 매뉴얼

PREPARE PARTS FOR ASSEMBLY

• PUSH THE DOWELS (PART A) INTO THE EDGES

OF THE FOLLOWING PARTS, AS SHOWN:

(PART 2) RIGHT SIDE

(PART 3) LEFT SIDE

(PART 6) BACK CASTOR SUPPORT

(PART 7) FRONT CASTOR SUPPORT

ATTACHING DRAWER RUNNERS:

• THE DRAWER RUNNERS (PART D) WILL STRETCH

SLIGHTLY AS YOU HAMMER THEM INTO PLACE.

• LINE UP THE PIPS IN DRAWER RUNNERS (PART D)

TO THE PRE-DRILLED HOLES IN THE RIGHT SIDE

PANEL (PART 2).

• EASE THE PIPS INTO THE HOLES BY TAPPING EACH

PIP DOWN HALF WAY. START ON ONE END, THEN

THE MIDDLE, THEN THE OTHER END.

• WHEN ALL 3 PIPS ARE HALF WAY DOWN AND THE

DRAWER RUNNER (PART D) IS STRETCHED,

HAMMER THE RUNNER ALL THE WAY DOWN UNTIL

IT IS FLUSH WITH THE RIGHT SIDE

PANEL (PART 2).

• REPEAT THESE STEPS TO ATTACH THE

DRAWER RUNNERS (PART D) TO THE

LEFT SIDE (PART 3).

TIP: Using a regular

hammer to attach the

runners provides a

clearer line of sight than

a rubber mallet.

NEXT PREPARE CASTER SUPPORTS:

• USE A HAMMER OR RUBBER MALLET TO INSERT

CASTER INSERT (PART Eb) INTO THE BOTTOM OF

THE FRONT CASTER SUPPORT (PART 7) AND

BACK CASTER SUPPORT (PART 6)

• TAP ABOVE THE BACK OF THE CASTER (ABOVE

THE STEM) TO ASSEMBLE CASTERS (PART Ea)

INTO THE CASTER INSERT (PART Eb).

A=12 Dowel

D=16

8,0 x 30mm

Drawer Runner

Eb=04

Ea=04

Caster & Insert

4/8

Perform the entire assembly on a

clean, hard surface using the

flattened box or a towel to protect

the surface and the unit's finish. DO

Carpet creates too much bounce

making assembly difficult and could

CONTAINED

NOT assemble on carpet.

lead to damage of the parts.

3rd

2nd

1st