adeptus 6+2 Drawer Wide Roll Cart 76169 Instrukcja montażu - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz adeptus 6+2 Drawer Wide Roll Cart 76169. adeptus 6+2 Drawer Wide Roll Cart 76169 8 stron. Matte black/white finish
Drukuj stronę
1
PREPARE PARTS FOR ASSEMBLY
• PUSH THE DOWELS (PART A) INTO THE EDGES
OF THE FOLLOWING PARTS, AS SHOWN:
(PART 2) RIGHT SIDE
(PART 3) LEFT SIDE
(PART 6) BACK CASTOR SUPPORT
(PART 7) FRONT CASTOR SUPPORT
ATTACHING DRAWER RUNNERS:
• THE DRAWER RUNNERS (PART D) WILL STRETCH
SLIGHTLY AS YOU HAMMER THEM INTO PLACE.
• LINE UP THE PIPS IN DRAWER RUNNERS (PART D)
TO THE PRE-DRILLED HOLES IN THE RIGHT SIDE
PANEL (PART 2).
• EASE THE PIPS INTO THE HOLES BY TAPPING EACH
PIP DOWN HALF WAY. START ON ONE END, THEN
THE MIDDLE, THEN THE OTHER END.
• WHEN ALL 3 PIPS ARE HALF WAY DOWN AND THE
DRAWER RUNNER (PART D) IS STRETCHED,
HAMMER THE RUNNER ALL THE WAY DOWN UNTIL
IT IS FLUSH WITH THE RIGHT SIDE
PANEL (PART 2).
• REPEAT THESE STEPS TO ATTACH THE
DRAWER RUNNERS (PART D) TO THE
LEFT SIDE (PART 3).
TIP: Using a regular
hammer to attach the
runners provides a
clearer line of sight than
a rubber mallet.
NEXT PREPARE CASTER SUPPORTS:
• USE A HAMMER OR RUBBER MALLET TO INSERT
CASTER INSERT (PART Eb) INTO THE BOTTOM OF
THE FRONT CASTER SUPPORT (PART 7) AND
BACK CASTER SUPPORT (PART 6)
• TAP ABOVE THE BACK OF THE CASTER (ABOVE
THE STEM) TO ASSEMBLE CASTERS (PART Ea)
INTO THE CASTER INSERT (PART Eb).
A=12 Dowel
D=16
8,0 x 30mm
Drawer Runner
A
A
A
D
D
Ea
A
Eb
A
7
Eb=04
Ea=04
Caster & Insert
4/8
Perform the entire assembly on a
clean, hard surface using the
flattened box or a towel to protect
the surface and the unit's finish. DO
A
Carpet creates too much bounce
making assembly difficult and could
A
D
D
D
2
D
D
D
D
D
Ea
Eb
A
Ea
A
Eb
A
A
CONTAINED
NOT assemble on carpet.
lead to damage of the parts.
3rd
2nd
D
1st
D
D
D
D
3
G
Ea
Ea
Eb
6
Eb
A
A
D