Emerson 210-2000 제품 정보 시트

{카테고리_이름} Emerson 210-2000에 대한 제품 정보 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Emerson 210-2000 4 페이지. Wall-mounted co2 sensor
Emerson 210-2000에 대해서도 마찬가지입니다: 설치 매뉴얼 (7 페이지)

페이지 인쇄

Overview

CPC's CO

sensor (P/N 210-2000) is a non-dispersive

infrared

analyzer

designed

environmental CO

concentration in ventilation

systems and indoor spaces. Its measurement range of

0-2000 or 0-5000 ppm covers the range required to

monitor compliance with ASHRAE and other

ventilation efficiency standards.

An LCD display is available to provide local indication

of CO

concentration and facilitate the setup and

calibration process. An adjustable setpoint relay is

available for direct control and alarm applications.

Microprocessor-based digital electronics and a

unique self-calibration algorithm improves long-term

stability and accuracy

Mounting

Before mounting, remove the door from the circuit

board by pressing a screwdriver against the locking

tab on the top of the enclosure. Pry the circuit board

Figure 1 - CO

Sensor (exploded view)

Carbon Dioxide Sensor

Product Information Sheet

for

measuring

away from the mounting plate using a screwdriver

inserted into the two tab slots on the top of the

enclosure.

Choose a location for the sensor with good air

circulation, away from ventilation inlets, doors,

windows, or other points where fresh air enters the

room. The sensor should be mounted at least 4-1/2

feet above the floor. The environment temperature

must be within 32°–112°F (0°–50°C).

If wiring will be coming in through the mounting

plate from the back, punch out openings in the

mounting plate and use the plate as a template for

locating holes. Mount the mounting plate against a

wall or other flat surface by using the two mounting

holes and the screws provided (use wall anchors for

drywall installations).

NOTE: Sensors must be mounted vertically (straight

up and down) to ensure proper readings.

210-2000