Emerson 210-2000 설치 매뉴얼 - 페이지 4
{카테고리_이름} Emerson 210-2000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Emerson 210-2000 7 페이지. Wall-mounted co2 sensor
Emerson 210-2000에 대해서도 마찬가지입니다: 제품 정보 시트 (4 페이지)
페이지 인쇄
5. With the sensor base fully installed, align the top cover to mounting tabs on top of the sensor base. Swing the cover
downward until it latches at the bottom.
6. Installed the locking screw to secure cover in a closed position.
7. The 400 ppm baseline calibration allows the sensor to be set at 400 ppm. Push and hold the calibrator button for 3 to 5
seconds. The LED will flash green. Once the push button is released, the calibration is complete and the LED is switched
off.
Mounting
1. Mount the backplate on the wall in an appropriate location with the "Install This End Up" label positioned in the upper
right corner.
2. Wire the unit as shown (see the Wiring section on page 5).
3. Attach the front plate.
Document Part # 026-4858 Rev 0
©2021 Emerson Digital Cold Chain, Inc. This document may be photocopied for personal use.
Visit our website at www.climate.emerson.com for the latest technical documentation and updates.
Page 4 of 7