Emerson FB1100 교체 매뉴얼 - 페이지 6

{카테고리_이름} Emerson FB1100에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Emerson FB1100 8 페이지. Flow computer coin cell battery field
Emerson FB1100에 대해서도 마찬가지입니다: 종단 보드 현장 교체 매뉴얼 (18 페이지), 교체 매뉴얼 (18 페이지), 현장 교체 매뉴얼 (14 페이지), 현장 교체 매뉴얼 (20 페이지), 현장 교체 매뉴얼 (8 페이지), 현장 교체 매뉴얼 (8 페이지)

FB1100/FB1200 Flow Computer Coin Cell Battery Field Replacement Guide

D301854X012

November 2020

10.

Removing/Replacing the Coin Cell Battery

Insert the new coin cell battery in the slot. The positive side (+) must be on top.

CAUTION

When inserting the SRAM coin cell battery push the battery gently into its slot until it

stops. The battery should slide in easily. Do not use excessive force.

To replace the HMI module, line up the printed circuit board (PCB) with the slot on the back

and gently press it back on. Tighten the four captive fastening screws with a torque of 4 to 6

in-lbs (0.5 to 0.7 N-m).

Carefully align the end cap threads with the threads of the enclosure and replace the front

end cap. Screw the end cap clockwise (eight full turns) until it is tightly sealed to the

enclosure. End caps must have at least 8 full threads engaged upon reassembly.

Note

If you need more leverage, place a long screwdriver or other appropriate tool across the two

notches in the end cap to act as a pry bar.

If applicable, tighten the retaining clamp onto the end cap using a 3mm hexagonal wrench.

When tightening, torque to 10 to 12 in-lbs (1.1 to 1.4 N-m).