AGROWPLOW AD230 매뉴얼 - 페이지 6

{카테고리_이름} AGROWPLOW AD230에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGROWPLOW AD230 7 페이지. Clutch update

페이지 인쇄
3. Assemble the new clutch assembly 
1.
Unscrew the grub screws securing the drive sprocket (640-4076) to the old clutch drive (640-4075). Wipe 
down the grub screws, apply a thin layer of thread locker, then secure the sprocket to the new zinc-plated 
clutch drive.  
2.
Wipe excess dirt from the clutch and clutch lever shafts and the interior of the clutch assembly bay. Brake 
cleaner spray will make this easier.  
3.
Apply a generous amount of grease to the clutch and clutch lever shafts.  
4.
Fit the new nylon fork (640-4324) to the new clutch lever pull (640-3086). Be sure to note which side of the 
clutch lever pull the wear plate is mounted to (see parts manual p41) .on the left of the clutch slide.  
5.
Swap the Farmscan magnet (640-4234) to the new clutch slide (640-4077) and refit it to the clutch shaft. 
You may need to adjust the position and angle of the hub and clutch shaft to provide enough clearance to 
fit the clutch slide.  
6.
Fit the assembled nylon fork and clutch lever pull to the clutch lever shaft and replace the assembly in the 
clutch bay, ensuring the fork is resting in the channel in the clutch slide.  
7.
Fit the new springs (132-2006) in the clutch slide.  
8.
Put the new clutch drive and sprocket back on the clutch shaft. You may need to sand back the igus 
bushes prior to fitting if they have been replaced. 
9.
Tighten the five nuts around the uni-hub and tighten the nut securing the clutch slide shaft on the hub 
side of the clutch bay.  
10. Replace the roll pin (140-4121) that secures the clutch slide on the clutch shaft. Ensure the roll pin is flush 
with the clutch slide.  
11. Replace the clutch lever pivot (140-3087) and spacer washer (135-3036) onto the clutch lever shaft, 
followed by the nut.  
12. Reattach the clutch arm to the clutch lever pivot. 
13. Refit the clutch lever spring.  
14. Hammer in the new roll pins (112-4036) on the end of the clutch shaft. 
15. Refit the chain on the drive sprocket, the chain tensioner, and the Farmscan pickup sensor.  
16. Use a grease gun to apply lubrication to the grease nipples on the clutch slide, the clutch lever pull, and 
the clutch fork groove on the clutch slide.  
 
 
 
Page
6