AGROWPLOW AD230 매뉴얼 - 페이지 7

{카테고리_이름} AGROWPLOW AD230에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGROWPLOW AD230 7 페이지. Clutch update

4. Calibration & testing

Ensure the drill is on a flat surface where both the wheels and tynes can touch the ground at the same time.

The clutch fork should be positioned centrally within the channel of the clutch slide. It requires a minimum of 1mm

between the fork and either outer edge of the channel.

Adjust the position of the fork within the clutch slide channel by tightening or loosening the M16 nyloc nut

(134-4022) on the end of the clutch fork shaft.

Raise the drill off the tynes to ensure the mechanism stays in place when the drill is raised and lowered, and

correct disengagement is applied when the drill is fully raised to ensure that the clutch is disengaged whilst in

transport mode.

Test both clutch engagement and positioning of the clutch fork several times to ensure the clutch fork is correctly

adjusted. This can be done by repeatedly engaging and disengaging the clutch as the seed drill is towed through a

paddock.

NOTE

If this upgrade is being performed as part of a

warranty claim, ensure suitable documentation

is captured as proof of completed work,

including photos and paperwork.

Page