AGROWPLOW AD230 Manuel - Sayfa 7

Çiftlik Ekipmanları AGROWPLOW AD230 için çevrimiçi göz atın veya pdf Manuel indirin. AGROWPLOW AD230 7 sayfaları. Clutch update

4. Calibration & testing

Ensure the drill is on a flat surface where both the wheels and tynes can touch the ground at the same time.

The clutch fork should be positioned centrally within the channel of the clutch slide. It requires a minimum of 1mm

between the fork and either outer edge of the channel.

Adjust the position of the fork within the clutch slide channel by tightening or loosening the M16 nyloc nut

(134-4022) on the end of the clutch fork shaft.

Raise the drill off the tynes to ensure the mechanism stays in place when the drill is raised and lowered, and

correct disengagement is applied when the drill is fully raised to ensure that the clutch is disengaged whilst in

transport mode.

Test both clutch engagement and positioning of the clutch fork several times to ensure the clutch fork is correctly

adjusted. This can be done by repeatedly engaging and disengaging the clutch as the seed drill is towed through a

paddock.

NOTE

If this upgrade is being performed as part of a

warranty claim, ensure suitable documentation

is captured as proof of completed work,

including photos and paperwork.

Page