Gallien-Krueger 2001RB 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Gallien-Krueger 2001RB에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger 2001RB 15 페이지. Bass amp and preamp
Gallien-Krueger 2001RB에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

Safety Information

Verify Line Voltage and Amperage Before Use: Your

amplifier has been factory configured for use with the

specific line voltage for your location only. For

example, units set to operate within countries that

supply 100-120 volt electrical service are not

compatible with 230-240 volt systems used in other

countries!

120 Volt/60Hz 15 amp circuit for the USA and

Canada.

230 Volt/(50/60Hz) 10 amp circuit for the UK and

Australia.

230 Volt/(50/60Hz) 10 amp circuit for Europe.

100 Volt/50Hz 15 amp circuit for Japan.

220 Volt/50Hz 10 amp circuit for Korea.

Proper AC circuit for all other countries.

Connecting the ampliﬁer to a line with speciﬁcations

other than indicated above can create a safety and ﬁre

hazard, and may damage the ampliﬁer. If you have any

questions about the voltage requirements for your

speciﬁc model, or about the line voltage in your area,

contact your dealer before plugging the unit into a wall

outlet.

Verify AC Circuit Capacity Before Use: The high

power output of your ampliﬁer may require heavy

current draw under full load conditions. To insure

proper performance and avoid potential safety hazards,

we recommend connection to line circuits with

amperage speciﬁed as above. Connecting multiple

ampliﬁers to the same circuit, or connecting the

ampliﬁer to the same circuit used by other heavy power

devices, such as high wattage lights, may cause circuit

breakers to trip. It is always a good idea to avoid using

any audio equipment on the same AC circuit as

equipment with motors, such as air conditioners or

refrigerators. This will lessen the possibility of power

variation and electrical start up noise affecting your

sound.

Warning: Do not disconnect or plug in the instrument

or the speaker cable with the amplifier power on. Be

sure the amplifier unit is turned off before connecting to

speakers.

2001RB

Do Not Use Extension Cords: To avoid safety hazards,

use only the power cord supplied with your unit. If a

replacement cord is used, make certain that it is of

consistent quality and gauge as the original. We do not

recommend using extension cords with this product. As

with all electrical devices, do not run power cords under

rugs or carpets or place heavy objects on them.

Damaged power cords should be replaced immediately

with cords meeting factory speciﬁcations.

Mains Disconnect: To isolate the unit from the AC

mains, disconnect the power cord from the unit and the

AC outlet. When disconnecting the power cord from an

AC outlet, always pull the plug, never pull the cord. If

you do not intend to use the ampliﬁer for a considerable

length of time, disconnect the plug from the AC outlet.

Do Not Open The Amplifier Enclosure: There are no

user serviceable components inside this product.

Opening the ampliﬁer enclosure may present a shock

hazard, and modiﬁcation to the product will void your

warranty. If liquid enters the unit, or any metal object

such as a paper clip, wire, or staple accidentally falls

inside the enclosure, disconnect the unit from the AC

power source immediately and consult an authorized

service station.

Unpacking: The carton and packing materials used in

shipping your new ampliﬁer were specially designed to

cushion it from the shocks and vibration that occur

during transport. We suggest that you save the carton

and packing materials for use in shipping, in the event

you move, or if the ampliﬁer needs repair.

Maximum Recommended Loads: Two 4 Ohm or four

8 Ohm cabinets per side, dual mono mode. One 4 Ohm

or two 8 Ohm cabinets in bridged mode. One or two 8

Ohm horns on the 50W Amps.