Gallien-Krueger 2001RB 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Gallien-Krueger 2001RB에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger 2001RB 15 페이지. Bass amp and preamp
Gallien-Krueger 2001RB에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

Quick Start

The 2001RB is designed to be simple to operate. All

controls have a well deﬁned purpose and are well

behaved. These directions will take you through the

basics and give you a good start for setting up your

sound.

Plug it in: Set the power switch to Off and connect the

supplied power cord, from the ampliﬁer AC receptacle,

to an AC power outlet of proper voltage and power

rating (see safety information on page 4 for details).

Connect your cabinets: Connect your speaker

cabinet(s) to the LEFT or RIGHT ¼" speaker jacks or

Speakon outputs if using our RBH series cabinets. Be

sure not to exceed the maximum recommended speaker

loads below.

Maximum recommended speaker loads: Two 4 ohm

or four 8 ohm cabinets per side in dual mono mode.

One or two 8 ohm horns per side on the 50W amp. To

connect other manufacturer's cabinets, use the LEFT or

RIGHT ¼" jack speaker outputs only.

If you are using an RBH Series cabinet, use a 4

conductor Speakon cable to connect to the Speakon

outputs on the rear panel of the ampliﬁer. In addition,

set the switch on the RBH cabinet to biamp.

For more information on bridged mode and biamped

mode, see pages 8-9.

Caution: Do not connect the Speakon cables labeled

'Bridge Mode' to the 2001RB. This may result in

damage to the ampliﬁer.

When using non GK cabinets that have Speakon

connectors, only use a standard two wire Speakon

cable. A four conductor Speakon style connector could

result in damage to your ampliﬁer.

Initial front panel control settings: Set all EQ

controls and the Boost control to 12 o'clock. The

Voicing Filters should be turned all the way down to get

a ﬂat response. Set the Level and Master Volumes at 0.

If you have a ﬁve string bass, push the button marked

String Bass in. Make sure the Level A/B button is out,

so you are in the clean channel.

2001RB

Plug in your bass: Using an instrument cable, connect

your bass to the Input jack and press the power switch

on. If you have active tone controls on your bass, turn

all of the controls to the middle or ﬂat position and turn

the volume all the way up. If you have conventional,

passive tone controls, turn all tone and volume controls

all the way up.

Level and Master Volume settings: Set the Master

Volume to 12 o'clock. Turn the Level-A volume up as

you play. Try not to turn it past 1 o'clock if you have a

bass with active tone controls unless you want an

overdrive effect. If the yellow clip light turns on, press

the -10db button in. If it is still on, try turning the

volume down on your bass.

At this point you should be hearing your bass quite

well. You can use the Volume and Woofer Master to

achieve a comfortable sound level. Remember, If you

need more volume, turn up the Woofer Master control

ﬁrst.