Gallien-Krueger 2001RB Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Gallien-Krueger 2001RB. Gallien-Krueger 2001RB 15 páginas. Bass amp and preamp
Também para Gallien-Krueger 2001RB: Manual do Proprietário (20 páginas), Manual do Proprietário (20 páginas)
Imprimir página
Quick Start
The 2001RB is designed to be simple to operate. All
controls have a well defined purpose and are well
behaved. These directions will take you through the
basics and give you a good start for setting up your
sound.
Plug it in: Set the power switch to Off and connect the
supplied power cord, from the amplifier AC receptacle,
to an AC power outlet of proper voltage and power
rating (see safety information on page 4 for details).
Connect your cabinets: Connect your speaker
cabinet(s) to the LEFT or RIGHT ¼" speaker jacks or
Speakon outputs if using our RBH series cabinets. Be
sure not to exceed the maximum recommended speaker
loads below.
Maximum recommended speaker loads: Two 4 ohm
or four 8 ohm cabinets per side in dual mono mode.
One or two 8 ohm horns per side on the 50W amp. To
connect other manufacturer's cabinets, use the LEFT or
RIGHT ¼" jack speaker outputs only.
If you are using an RBH Series cabinet, use a 4
conductor Speakon cable to connect to the Speakon
outputs on the rear panel of the amplifier. In addition,
set the switch on the RBH cabinet to biamp.
For more information on bridged mode and biamped
mode, see pages 8-9.
Caution: Do not connect the Speakon cables labeled
'Bridge Mode' to the 2001RB. This may result in
damage to the amplifier.
When using non GK cabinets that have Speakon
connectors, only use a standard two wire Speakon
cable. A four conductor Speakon style connector could
result in damage to your amplifier.
Initial front panel control settings: Set all EQ
controls and the Boost control to 12 o'clock. The
Voicing Filters should be turned all the way down to get
a flat response. Set the Level and Master Volumes at 0.
If you have a five string bass, push the button marked
String Bass in. Make sure the Level A/B button is out,
so you are in the clean channel.
2001RB
Plug in your bass: Using an instrument cable, connect
your bass to the Input jack and press the power switch
on. If you have active tone controls on your bass, turn
all of the controls to the middle or flat position and turn
the volume all the way up. If you have conventional,
passive tone controls, turn all tone and volume controls
all the way up.
Level and Master Volume settings: Set the Master
Volume to 12 o'clock. Turn the Level-A volume up as
you play. Try not to turn it past 1 o'clock if you have a
bass with active tone controls unless you want an
overdrive effect. If the yellow clip light turns on, press
the -10db button in. If it is still on, try turning the
volume down on your bass.
At this point you should be hearing your bass quite
well. You can use the Volume and Woofer Master to
achieve a comfortable sound level. Remember, If you
need more volume, turn up the Woofer Master control
first.
5