Gallien-Krueger Fusion 550 소유자 매뉴얼 - 페이지 5
{카테고리_이름} Gallien-Krueger Fusion 550에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger Fusion 550 12 페이지. Gallien-krueger fusion 550: user guide
Gallien-Krueger Fusion 550에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)
페이지 인쇄
Quick Start
Plug It In:
Set the power switch to Off and con-
nect the supplied power cord to the amplifier's AC
receptacle and an AC power outlet of proper voltage
(see safety information on page 4 for details).
External Cabinets:
If using an external speaker
cabinet, connect it to the free speaker output. If you
are using two 8 ohm or one 4 ohm external cabinet
with a combo amplifier, disconnect the internal speaker.
Be sure not to exceed the recommended speaker load
below.
Maximum Recommended Speaker Loads:
EXTERNAL
TOTAL
SPEAKER(S)
LOAD
1 x 8 ohm
8 ohms
1 x 4 ohm
4 ohms
2 x 8 ohm
4 ohms
Note: If you are using a GK Horn Bi-Amp compatible
speaker cabinet, set it to Bi-Amp using the switch on
the back of the cabinet. (See Page 8 for more details
on GK's Horn Bi-Amp System)
Initial Front Panel Control Settings:
tive equalizer controls and contour to 12 o'clock, and
the bright and deep switches off. Set the Gain and
Master Volumes to 0.
Connect Your Bass: Using an instrument (shielded)
cable, connect your bass to the Input jack and press
the power switch on.
Input and Master Volume Settings: Set the master
to 12 o'clock then gradually increase the Gain con-
trol to a comfortable listening level. If using a passive
bass, set input switch to passive. With an active bass,
it maybe necessary to set the input attenuator switch
to active. This is only required with very high output
active basses resulting in distortion from over driving
the input stage.
Fusion 550 Bass Amplifier
Set all ac-
5