Gallien-Krueger Fusion 550 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Gallien-Krueger Fusion 550에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger Fusion 550 12 페이지. Gallien-krueger fusion 550: user guide
Gallien-Krueger Fusion 550에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)

페이지 인쇄

Horn Bi-Amp System (HBS):

Your amplifier incorporates GK's unique HBS. This feature is automatically engaged when you con-

nect to a GK HBS compatible enclosure, giving you independent control of the tweeter and woofer

signals. Now you can push the woofers to the max while the tweeter remains clean, crisp, and free of

clipping distortion. A smooth tight tone is easily dialed in by adjusting the Horn and Woofer Master

controls on the amplifier's front panel.

Horn Bi-Amp Mode:

Horn Bi-Amp compatible bass cabinet. Use a

properly wired four-conductor Speakon cable to

connect to your cabinet. Set the switch on the back

of your GK HBS compatible enclosure to Bi-Amp.

In this mode, the cabinet's internal crossover is

bypassed. Use the Woofer/Main knob to control

the output signal to the woofer, and the Horn knob

to control the output signal to the horn.

Note: The 50W horn amplifier has a fixed frequency

output of 5kHz and up (high frequencies only). It

will not provide a usable signal to drive a separate

speaker cabinet.

GK Speakon Cable Wire Configuration:

1+ Woofer Amp +

Woofer Amp -

2+ Horn Amp +

Horn Amp -

Fusion 550 Bass Ampliﬁer

BI-AMP MODE

FULL RANGE MODE

This mode requires a GK

Full range Mode:

with virtually any standard bass cabinet. Use a

two-conductor Speakon cable or a ¼" speaker

cable to connect to your cabinet. If using a GK

HBS compatible enclosure, set the switch on the

back of the cabinet to Full range. In this mode,

the cabinet's internal passive crossover is used to

split the signal between the woofer and horn. Use

the Woofer/Main knob on the front of the amplifier

to control your output level. The Horn knob is not

used.

Note: To avoid the risk of damage to the amplifier,

do not use a four-conductor Speakon cable with non

GK cabinets. Instead use a two-conductor Speakon

or ¼" speaker cable.

CAUTION:

UNDER NO CIRCUMSTANCES

SHOULD THE WOOFER/MAIN AMP AND

THE 50 WATT HORN AMP BE CONNECTED

TOGETHER!!!

This mode is compatible