HighSecLabs FVFE11PH-M 빠른 설정 매뉴얼 - 페이지 8

{카테고리_이름} HighSecLabs FVFE11PH-M에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighSecLabs FVFE11PH-M 10 페이지. Secure kvm extenders
HighSecLabs FVFE11PH-M에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (9 페이지)

페이지 인쇄

SECTIONS

Table of Contents

oPERaTIoN

Running an EDID Capture

before using the Extender, run a one-time EDID capture on both sides

– Transmitter and Receiver. This prevents the continuous transfer of

potentially malicious data - from the display to the PC – that could

infect the PC, cause data leakage, and so on.

Preparation:

• Connect the PC and all peripherals to both the units, according to

the Installation Instructions.

• Make sure the PC, display, and the units are oN.

To run an EDID capture:

1. on the Receiver, short-click the EDID lock button. Wait 5 seconds

and then restart the unit, by unplugging the network cable and

power supply. at first, the EDID lED flickers for a few seconds and

then, once captured lights green continuously.

2. Make same on the Transmitter, short-click the EDID lock button,

wait 5 seconds and then restart the unit. The EDID lED will now light

green continuously.

Note: If the EDID lED is off, check the connections and that the PC

or the Display are powered oN. Then, repeat the procedure.

3. Restart both units.

Note: an EDID capture needs to be performed for new installations

and when changing a display.

HSL Secure Extended Isolators Quick Setup Guide

EDID LED

EDID Lock Button

EDID LED

EDID Lock Button

Receiver

Transmitter