highwood Sequoia Professional Ridgecrest 조립 설명서 - 페이지 2
{카테고리_이름} highwood Sequoia Professional Ridgecrest에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. highwood Sequoia Professional Ridgecrest 16 페이지. Commercial grade
페이지 인쇄
A
1/4"-20 X 1.25"
B
1/4"-20 X 2.00"
C
#7 x 2.25"
D
#7 x 3.00"
E
#8 x 1.00"
F
SEQUOIA
PROFESSIONAL
by
highwood
x16
x96
x16
ANCHORS SUITABLE FOR THE INSTALLATION
x72
SURFACE (MAX.
x20
x8
For information on Care and Cleaning or to register your SEQUOIA
PROFESSIONAL product by highwood , please visit
www.highwood-usa.com.
INCLUDED TOOLS
5/32" HEX BIT (Bolts A , B )
#2 SQUARE BIT (Screw E )
T15 TORX BIT (Screws C , "D")
CUSTOMER-SUPPLIED HARDWARE
5
" DIAMETER).
16
CUSTOMER-SUPPLIED TOOLS
CORDLESS DRILL/SCREWDRIVER
LADDER
LEVEL
TAPE MEASURE
1
" DRILL BIT
8
TOOLS NECESSARY FOR CUSTOMER-SUPPLIED ANCHORS
IMPORTANT!
A MINIMUM of (2-3) people are required to assemble this product.
DO NOT expose components to direct sunlight prior to assembling.
Remove components from the box as they are needed for assembly.
DO NOT fully tighten the bolts until all bolts are started.
Once all bolts are inserted, go back & tighten all bolts.
Ensure all pre-drilled holes are clear of any debris.
This will allow for easier assembly.
Retain these instructions for future reference
x16
CM-PGLA-1212
04.30.21
PAGE 2 of 16