Agrowtek AgrowDose 사용 및 유지 관리 지침 - 페이지 7

{카테고리_이름} Agrowtek AgrowDose에 대한 사용 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Agrowtek AgrowDose 11 페이지.

BatchMaster Software Setup

Setup

To setup and install the free software you must be using a Windows operating system.

1. Download the installer from Agrowtek's website.

2. Open the installer and follow the command prompts.

3. If you are given a security warning asking permission to modify files (install them,) select YES.

Connect the USB AgrowLINK and allow the drivers to automatically install. Wait until a message is displayed

in the task bar indicatin the device is ready to use (it may take several minutes.) If the device drivers fail to

install, you can install them from the BatchMaster software.

Driver Installation

If the device drivers have not automatically installed:

1. Open the BatchMaster program.

2. Ignore warnings that advise the AgrowLINK was not detected (press OK.)

3. From the top menu bar select: USB AgrowLINK > Install Driver.

4. The driver installer will open; follow the command prompts to complete the driver installation.

Detect the AgrowLINK

If your AgrowLINK was not connected before you opened the program, you can search for it by selecting:

USB AgrowLINK > Detect AgrowLINK.

Each pump may have a setting for the dose volume (mL) and the flow rate of the pump (mL/min).

To create a batch recipe:

1. Set the flow rate for each pump. Most applications will use the pumps at full speed. The speed may be

reduced if required for your application.

2. Set the volume that each pump should dose.

3. Save the recipe if desired by selecting: File > Save. Choose a location and name the file then press "Save. "

Saved recipies may be recalled by selecting: File > Open and choosing a recipe file.

Run a Batch

Once the recipe is configured, it may be "run" by pressing the green "play" button. The pumps will begin dos-

ing with the first pump. Once the specified volume is completed, the next pump will begin. When all pumps

have metered the volume in the recipe, the batch is complete.

Stop Pumps

All pumps may be stopped immediately by pressing the red "stop" button.

Prime

Each pump may be primed for 10 seconds automatically by pressing the "Prime" button for the respective

pump. The pump will operate at the speed selected allowing the speed to be previewed or tested.