GALTRONICS 62-20-09 안테나 설치 - 페이지 3

{카테고리_이름} GALTRONICS 62-20-09에 대한 안테나 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. GALTRONICS 62-20-09 3 페이지. Top mounting bracket on pole for odas antennas

Baylin TechnOlogies Company

Assemble right bracket stopper plates and left bracket (Clamping brackets)

Use 7/16" fasteners to attach the support bracket,

stopper plates and left brackets without tightening (see details).

For a pole with diameter between 9" - 12", position the interlock

tabs of the stopper plates towards the support

bracket (see picture detail on the left).

For 6" - 9" pole diameters position, the interlock tabs

away from the support backet.

Tightening hardware to the final position

will be done after placing the antenna

on the pole!

Ultra Flat In-Building SISO Antenna [698-960MHz, 1695-2700 MHz]

Antenna Mounting

Place the antenna rod on top of the pole and adjust the position

of the right bracket to the center of the pole. Tighten all bolts.

Cup Head Screw Installation

Install 5/16" cup head set screw and

tighten to the appropriate torque. Lock

the antenna rod using the nylon flange

locking hex nut. Tighten hex nut to 15Nm

(132In*Lbs).

DO NOT REUSE LOCKING HEX NUT.

ONLY USE NEW LOCKING HEX NUTS

FOR ANTENNA MOUNTING ADJUSTMENTS.

Check Torque

After adjustment all loosened bolts

must be tightened with a torque of:

5/16˝ - 15Nm (132In*Lbs)

7/16˝ - 40Nm (354In*Lbs)

1˝ - 150Nm (1328In*Lbs)

7/16" Nut

7/16" Plain and

Spring Washer

w w w . g a l t r o n i c s . c o m

Model No: 62-20-09 | Top Mounting Bracket on Pole for oDAS Antennas

7/16" X 1

7/16" Plain Washer

Antenna Rod / 1" Mount Adapter Rod

/ 2 "

5/16" - Nylon Flange

Lock Nut (2x)