GALTRONICS 62-20-09 Instalação da antena - Página 3
Procurar online ou descarregar pdf Instalação da antena para Racks & Stands GALTRONICS 62-20-09. GALTRONICS 62-20-09 3 páginas. Top mounting bracket on pole for odas antennas
Imprimir páginaBaylin TechnOlogies Company
B.
Assemble right bracket stopper plates and left bracket (Clamping brackets)
Use 7/16" fasteners to attach the support bracket,
stopper plates and left brackets without tightening (see details).
For a pole with diameter between 9" - 12", position the interlock
tabs of the stopper plates towards the support
bracket (see picture detail on the left).
For 6" - 9" pole diameters position, the interlock tabs
away from the support backet.
Tightening hardware to the final position
will be done after placing the antenna
on the pole!
Ultra Flat In-Building SISO Antenna [698-960MHz, 1695-2700 MHz]
C.
Antenna Mounting
Place the antenna rod on top of the pole and adjust the position
of the right bracket to the center of the pole. Tighten all bolts.
.
D
Cup Head Screw Installation
Install 5/16" cup head set screw and
tighten to the appropriate torque. Lock
the antenna rod using the nylon flange
locking hex nut. Tighten hex nut to 15Nm
(132In*Lbs).
DO NOT REUSE LOCKING HEX NUT.
ONLY USE NEW LOCKING HEX NUTS
FOR ANTENNA MOUNTING ADJUSTMENTS.
.
E
Check Torque
After adjustment all loosened bolts
must be tightened with a torque of:
5/16˝ - 15Nm (132In*Lbs)
7/16˝ - 40Nm (354In*Lbs)
1˝ - 150Nm (1328In*Lbs)
Proprietary Information. All rights reserved. Galtronics reserves the right to modify or amend any antenna or specifi cation without prior notice.
7/16" Nut
7/16" Plain and
Spring Washer
Copyright © 2017 – Galtronics Corporation Ltd.
w w w . g a l t r o n i c s . c o m
Model No: 62-20-09 | Top Mounting Bracket on Pole for oDAS Antennas
7/16" X 1
7/16" X 1
7/16" Plain Washer
Antenna Rod / 1" Mount Adapter Rod
1
/ 2 "
1
/ 2 "
5/16" - Nylon Flange
Lock Nut (2x)