CorAccess Mobile Companion 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} CorAccess Mobile Companion에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CorAccess Mobile Companion 9 페이지.

Mobile Companion Quick Start Guide --- Windows CE 3.0

OPERATION

To turn the Mobile Companion on, push and quickly release the power switch to the right of the front

bezel.

The power LED on the Mobile Companion will then turn green indicating that the Mobile

Companion is ready to use. To turn the Mobile Companion off, push and hold the power switch for about

4 seconds, the power light and display will go off. A beep will also sound. You can also use soft controls

for Power mode and Sleep mode access – use the "Device Shut Down" icon on the TaskBar.

Start Up

1. Turn on the power, and after several seconds the Windows CE desktop will be displayed.

2. Choose from any of the displayed icons to activate the corresponding application.

Calibration

1. The Calibration Properties screen will appear next if this is a new or reset device. When the

Mobile Companion prompts you to calibrate the touchscreen, use the Stylus (stored in the upper

right surface of the Mobile Companion ) and tap where indicated on the touchscreen in accordance

with the instructions.

(This document refers to "clicking" or "tapping" interchangeably. The latter is applicable when

the touchscreen is utilized).

NOTE: You can recalibrate at anytime using either:

(1) "Start" ! "Setting" ! "Control Panel" ! "Stylus" or

(2) Pressing the Soft Keyboard and E-mail buttons at the same time.

1. Click "Start" on the Windows CE Taskbar, select "Settings", and then click on "Control panel".

2. The Control Panel displays several icons associated with utilities for configuring the Mobile

Companion. Many of these are self-explanatory. Some major ones are discussed below.

a) Display Quality set up

i) Click on "Display". The Display Properties window will appear.

ii) You can use "Brightness" to adjust the brightness of the displayed images. Tap on the left

arrow to set the display darker or on the right arrow to increase the brightness.

b) Network Configuration

i) Double-click on "Network" icon.

ii) Click on "Network", the Network Configuration will appear.

iii) Click on "Adapters", a list of the network drivers installed on your device will be displayed.

Select the adapter that you currently use, then click on "Properties".

iv) You have two options: "Obtain an IP address via DHCP" or "Specify an IP address".

v) When you select "Obtain an IP address via DHCP", you are expecting that an IP address can

be automatically assigned to this device. Then click on "OK" at the top of the window for

confirmation.

Page 4 of 8

Nov, 2001