CorAccess Mobile Companion Посібник із швидкого старту - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Домашня автоматизація CorAccess Mobile Companion. CorAccess Mobile Companion 9 сторінок.
Друкувати сторінку
Mobile Companion Quick Start Guide --- Windows CE 3.0
OPERATION
Power ON and OFF
To turn the Mobile Companion on, push and quickly release the power switch to the right of the front
bezel.
The power LED on the Mobile Companion will then turn green indicating that the Mobile
Companion is ready to use. To turn the Mobile Companion off, push and hold the power switch for about
4 seconds, the power light and display will go off. A beep will also sound. You can also use soft controls
for Power mode and Sleep mode access – use the "Device Shut Down" icon on the TaskBar.
Start Up
1. Turn on the power, and after several seconds the Windows CE desktop will be displayed.
2. Choose from any of the displayed icons to activate the corresponding application.
Calibration
1. The Calibration Properties screen will appear next if this is a new or reset device. When the
Mobile Companion prompts you to calibrate the touchscreen, use the Stylus (stored in the upper
right surface of the Mobile Companion ) and tap where indicated on the touchscreen in accordance
with the instructions.
(This document refers to "clicking" or "tapping" interchangeably. The latter is applicable when
the touchscreen is utilized).
NOTE: You can recalibrate at anytime using either:
(1) "Start" ! "Setting" ! "Control Panel" ! "Stylus" or
(2) Pressing the Soft Keyboard and E-mail buttons at the same time.
Configuring your device
1. Click "Start" on the Windows CE Taskbar, select "Settings", and then click on "Control panel".
2. The Control Panel displays several icons associated with utilities for configuring the Mobile
Companion. Many of these are self-explanatory. Some major ones are discussed below.
a) Display Quality set up
i) Click on "Display". The Display Properties window will appear.
ii) You can use "Brightness" to adjust the brightness of the displayed images. Tap on the left
arrow to set the display darker or on the right arrow to increase the brightness.
b) Network Configuration
i) Double-click on "Network" icon.
ii) Click on "Network", the Network Configuration will appear.
iii) Click on "Adapters", a list of the network drivers installed on your device will be displayed.
Select the adapter that you currently use, then click on "Properties".
iv) You have two options: "Obtain an IP address via DHCP" or "Specify an IP address".
v) When you select "Obtain an IP address via DHCP", you are expecting that an IP address can
be automatically assigned to this device. Then click on "OK" at the top of the window for
confirmation.
Page 4 of 8
Nov, 2001