Coral Coral Series 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} Coral Coral Series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coral Coral Series 15 페이지. Cabinet

Overflow Connection.

The overflow connection is the white ½" hose spigot on the rear or side of

the cabinet. A clip is not required for this connection. The overflow must be

run downhill through an outside wall without kinks or restrictions. It is

recommended the overflow hose be visible when it exits the outside wall.

Electrical Connection.

Connect the transformer provided to a continuous electrical supply with the

power off. Plug the flying lead from the transformer into the electrical

connection on the controller (see programming instructions). Ensure the

flying lead cannot get caught on the camshaft or any moving parts on the

Softener valve.

Preparing the Softener to go into service.

Now that all the connections have been completed put approximately 5 litres of

water into the brine tank. You may also at this point put a quantity of salt into

the tank. Do not allow the salt level in the brine tank to exceed the height of the

overflow. The amount of salt used will depend on the type and model of

Softener you have, you should never let the brine tank become completely

empty of salt and it is advisable to check the salt levels on a regular basis until

a usage pattern has been established, normally the salt level should be above

the water line.

Putting the Softener into service.

You should now complete any programming instructions that may apply to

your particular Softener. During the commissioning process and initial

regeneration you can confirm that the unit has no leaks from the installed

valves and that waste water runs freely. This regeneration will also assist in

cleaning any potential air locks that may be present within the system.

The regeneration will also reset any internal meter or timer devises that

dictate the frequency of the regeneration cycle.