Coral Coral Series 설치 및 운영 매뉴얼 - 페이지 6

{카테고리_이름} Coral Coral Series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coral Coral Series 15 페이지. Cabinet

The main user guide should only be used for reference purposes,

please use this guide for initial programming.

Your softener should already have been set up with the basic settings in

The only settings you should need to enter are the Time of Day, Day of

Week and the Water Hardness where applicable.

Button descriptions.

Before starting this process please ensure that the softener is connected

correctly to the water, waste and power supply.

Quick Set Up Guide

the factory.

Plug the transformer into the rear of the control panel; this

is located to the left top corner of the panel if viewing from

the front. Once the power is connected the display may

briefly show the valve type (255 or 268). The valve type

will be printed on the side of the valve and should also

appear on the delivery documentation. On occasions the

display may flash between the time and regeneration

symbols, press the set button to clear this.

Note. During the set up process the display may revert to

normal mode (after 25 seconds).

By repeatedly pressing the up or down arrow button you

can scroll to the part of the set up programme you require.

If you receive an ERR3 message allow the cam shaft to

turn for a few moments and this code should disappear. If

the cam does not move check that the Cam Shaft is fitted

correctly and that the optical sensor is in position.

1. Down arrow. Used to scroll

down or increment through

a group of choices.

2. Set. Used to accept a setting to

store in the memory.

3. Up arrow. Used to scroll up or

increment up through a group

of choices.

4. Regenerate. Used to command

the controller to regenerate.