Coral Mistral Series 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} Coral Mistral Series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coral Mistral Series 15 페이지. Cabinet

Positioning the Softener.

Where possible the softener should be placed close to the rising main. Take

care to allow hard water take off points for a drinking water facility and /or an

outside tap. The distance between the drain and the Softener should be as short

as possible. Ensure that both the drain and overflow will not freeze or reach a

temperature above 40°C. If putting the Softener within a cupboard ensure that

the base is adequately supported. If the Softener is being installed within your

loft etc it is recommended to house the Softener within a tank capable of storing

at least 100 Litres with an overflow fitted. The overflow on the tank should be

below the Softener overflow and be a minimum of ¾" in size.

A single Check Valve.

A suitable check valve should be fitted. This will usually be in the

installation kit that can be ordered separately.

Check List.

Before you start the installation make sure that

you have all the necessary fittings. The

purchase of one of our standard installation kits

will normally ensure that you have everything

that you need for a typical installation

Water Pressure Test.

It is important that a pressure test is carried out.

High and low water pressure can result in either

damage to or failure of the Softener. Although

the Softener is tested to a pressure of 8 bar

(120psi), we recommend the fitting of a pressure

limiter should your pressure exceed 5 bar (70

psi). The minimum working pressure is 1.4 bar (20 psi)

Before starting the installation of the valves ensure that the stop cock is in

the closed position.